[RESOLVED] Can't force PBX to 'playfield' monitor

[MulletLife]

Hello
This seems to be an issue sometimes when I clone my drive for back up purposes. 
It doesn't seem to matter what screen I set the playfield to, it will only show on the backglass or DMD. (3 screen setup)

Once I load VPX, everything is fine. This is a front end issue only. PBX just doesn't want to move to my playfield (Windows ID#2)

In Windows, Playfield=2, BG = 1, DMD =3.  This setup has always been fine. My playfield doesn't have to be #1.  (PF - GPU - HDMI. BG - GPU - DVI.  DMD-Onboard-VGA)

Everything seems fine visually, I'm not brand new to this. I have had, and fixed this before but can't remember what I did. 
PBX 5.02 freshly installed, no change. 

I can get logs etc from the vpin if needed/helpful. 

Thanks everyone!

[Mike_da_Spike]

Yes. Logs and pinballx.ini would be helpfull

[MulletLife]

I edited the config file to match the resolution of the playfield screen (it was set to 1920x1080). That seemed to be the issue??? Resolved for now.