Pinballx skips(jump) tables

[starac]

If I use the keyboard everything is ok, but over the pinscape controller([JOYCODE_1_BUTTON6] or( [JOYCODE_1_BUTTON5])left to right skips the table....He skips 3 table or 2 jump...

Strangely I can't choose a certain table he just skips the tables ..he chooses at his discretion

On all versions pinballx

[scutters]

Do you have magna save (page) buttons mapped the same as left/right flippers?

You need to attach your log.txt and pinballx.ini files!

Also, is this is new controller (and buttons ok in game etc)? Thanks

[Tom Speirs]

Attach your logs and I will give you a patch to test.

[Tom Speirs]

I have had a look, the repeat rate is 600 milliseconds which should be plenty.

However it is global across all buttons/directions.

So I suspect the issue is because you have a button held down or  there is an issue with getting the system tick count but this would screw up a lot of things.

[Mike_da_Spike]

8 hours ago, Tom Speirs said:

So I suspect the issue is because you have a button held down or  there is an issue with getting the system tick count but this would screw up a lot of things.

I had the same with my vpincontroller.

My switch of my 2 euro coin chute was "pressed" (it was stuck and the button was constantly pressed)

I didn't noticed anything, but PBX behaved steange when I wanted to go to the next table. Every menu item selected multiple entries. 

Checking my joy buttons in windows, I noticed 1 was pressed. Fixing that dipswitch, al was working fine for me 

[starac]

Everything is perfect via the keyboard ... I'll answer later because I don't have a cabinet at hand