Problems with Gamepad navigation on menu

[skudfisher]

Ok. I tried to search for an answer to this as thouroughly as I could and did not find a solution. Right now if I use the keys to rotate through the menu it works as expected. But if I try to use the buttons on my cabinet which are mapped to gamepad buttons, I get super weird inconsistent stuff happening. Sometimes the buttons do nothing, and sometimes it zooms past about 40 tables all in about half a second.

I'm using x360ce to build a virtual 360 controller using a GeeekPi USB Encoder. At one point it was all working fine and now suddenly it's not and I'm not sure exactly what I did. It seems possible it's reading both the raw GeekPi input and the virtual 360 input at the same time and it's doubling or cancelling out input. Does PinballX read inputs from all controllers connected as if they were the same controller?

I'm not sure if I am explaining all this clearly but I'm starting to lose my marbles getting this all setup.

I should say that if I load Zaccaria, Visual Pinball or PX3 directly everything works completely fine so it's something specific to PinballX that is not working properly regarding controller input.

Thanks!

log.txt PinballX.ini

[skudfisher]

Update on this: I've eliminated the double gamepad input as the source of the problem. I ran some input tests and there is only a single controller being detected even at the base/raw level.

So why would PinballX go all wonky with navigating the radial menu with a gamepad and not the keyboard?

[Tom Speirs]

Im not sure off hand but to let you know - PinballX uses directinput for gamepad input and scans all connected devices. According to your log it is connecting two devices.

[Mike_da_Spike]

Do you have your GeeekPi USB Encoder behind an usb hub or directly attached to your main board?