[SOLVED] Buttons from 2nd Joystick , saved as 1st joystick button in settings ? (this is normal behavior)

[Mike_da_Spike]

I run out of buttons on my pinball cab, so I'm playing arround with an Elgata Stream Deck
I don't want a key board attached and this device can do a lot of stuff.

For adding extra joystick keys, I installed vJoy and assign it to the Stream deck as a button
Within Windows, the vJoy is identified and working (see that keypress 4 is working)


Setting up in Settings.exe for example a Pause/Ingame to that button, it shows as Joystick2_Button4 :

When gogin to the next page (and go back to the previous, it is saved as Joystick1_button4 (but my page/nudge is already assigned to it)

Also in the Ini file, the Joycodes is the same numver for pageright and ingame

 

[JoyCodes]
quit=6
left=0
right=1
select=5
rotate=
pageleft=2
pageright=3
exitemulator=6
ingame=3
instructions=15
launch=4
Credit=
Plunger=0

Launching PinballX, it shows that it found 2 joysticks.
Is this something I do wrong, or is this a limitation in PinballX ?
 

PinballX.ini log.txt

Edited May 20, 2021 by Mike_da_Spike
Marked to solved, as this is normal behavior)

[Mike_da_Spike]

@Tom Speirs, not to rush you Tom, but did you read this post ?

[Tom Speirs]

Its a limitation.  PinballX will read from all connected devices but controls set are global.

[Tom Speirs]

PS: You can imagine that if this was possible it could cause a lot of user issues as gamepad changes would break everything.

[Mike_da_Spike]

Gotcha ! Thanks Tom