PBX loading wrong PBFX3 table

[Ellite]

When using pinballX 3.06 to load pinball fx3 tables the wrong table is loaded. Have tried using the parameters -applaunch 442120 "-table_[TABLEFILE]" and -applaunch 442120 with no success on either. I have not enabled cab support yet as I am on my test system and want to work out the bugs before I put it on my pincab. I didn't know if I could use the cab support code on both systems or not, or it was a one time code to use, so I would want to use it on my pincab and not my test system. Pinballfx 3 loads fine just not selecting the correct table. 

[Ellite]

Just curious if anyone else has had an issue that is similar to this on PBFX3? If so how to fix it to where the correct table is selected when running through PBX.

[Draco1962]

Seems a bit odd. Can you attach copies of your log.txt and pinballx.ini files?

[Ellite]

Thanks for the reply. I didn't know if I would get any help with this since in version 2.42 and up it is supposed to select correct table for you without using a grid selection, like what was used for pbfx2, unless you had a third party "software" like the N***L*****er that would select it for you without using the "grid" selection in PBX. I will get those posted when I get home. Thanks again.

[Ellite]

Here are the files you requested. Hope you can find something that I'm over looking. I am at a loss with getting it to work correctly. Thanks again.

log.txt

PinballX.ini