|
Search the Community
Showing results for tags 'document'.
Found 2 results
-
When you need to remove the flash.ocx ,because your log file shows: 01:21:02.14 10/26/1985: Please try deleting flash.ocx in the installation folder and then reininstall PinballX. 01:21:02.14 10/26/1985: You may need to change security properties on the file. 01:21:02.14 10/26/1985: If PinballX does not initialize you should address this issue. It could be a difficult thing to remove the file. I hope this tutorial will make it easier. Navigate to your PinballX folder via the windows explorer (My example is in c:\pinball\PinballX, but could be installed in another drive/folder) and locate flash.ocx. Right click on it and select Properties Click on the security Tab and select Edit In the Permisissions for FlashOCX, make sure Everyone is selected And click on the Allow Full Control Click Apply and click OK after that Now click on Advanced There will be 2 entries for Everyone. Select the Deny Everyone and click remove Click again on Apply and click OK Click OK to close the window Now you are able to delete the Flash.ocx file
-
This thread is for PinballX setup documentation only. Please review and use the attached template (courtesy of nullPointer) which is in .docx format. PinballX_S2F_Documentation_Template.7z Please may contact either nullPointer or myself via PM with your final drafts (please send the docx file via .zip/.rar/7z as an attachment) for review and posting within this thread. You may post any questions regarding any content here and addressed to the document's author. Thank you.
