I am completely stumped. I have a great DMD displayed on my backscreen monitor. It works excellently for all my DMD enabled tables. To get this DMD right I used SETDMD to get them into a rough position and went through my registry to dial them in. They all worked great. Alas I was setting up my PinballX and when the dust settled I noticed that my DMD disappeared from all my table. I used the proverbial ALT/Tab to select the DMD screen, but nothing was there. I exited out of Pinballx and went back into VP, still no DMD. I pulled up my SETDMD utility and did an update to install my DMD baseline to all installed ROMs. I ran the table again under VP and the DMD was right as rain, albeit it needed dialing in again. I ran PinballX again and paid attention to the DMD. The DMD came up on the backscreen first, than the B2S artwork. A split second later the DMD was gone and the music started. I looked for the DMD using the ALT/TAB and again nothing. I recorded all the setting in the registry, must have been close to 100 values and compared them to the registry values when the DMD was working. NO DIFFERENCE. So here is my set up-
playfield 1920x1080 on left
Backscreen 1280x1024 on right
Visual Pinball 9.9.5
VpinMAME 3.1 32 bit
OS Windows 7, 64
PinballX September 2018 release
use DirectB2S in front end NO
Auto pos NO
DMD enabled NO
DMD display DISPLAY 2
DMD auto pos NO
DMD settings x 2250 y 785 600 x 115
I tried running VB 9.9.5 in WIN NT MODE - No change
I am running everything in ADMIN mode - No change
I shook the sacrificial chicken at it (several times) - No Change
I even check the air in the tires man - No Change
Any suggestions would be greatly appreciated
Thank you in advance,
Rickey
[SETTINGS].log
log.txt
PinballX.ini