|
Search the Community
Showing results for tags 'Arcadevga3000 Mame'.
Found 1 result
-
Hey Guys, So I decided to move to a true graphics card for my cab in the hope it would make the world of difference. However after installing the card even Gameex menus run slow where as before they were lightning fast? And now when i select a mame game it goes to load then quickly flashes back to the information screen right before launching the rom. My computer specs are Arcadevga3000 (previously a crap x550) Asus Rampage formula x48 Intel Xenon 5.5ghz dual core Hyperx ram 1044 4gb Rampage sound card Corsair PSU 2tb HDD x 2 Windows 7 64bit So i am at a bit of a loss here as to what might have happened ? or as to why it runs like a dog. Anyone had similar issues with one of these? Also in my settings according to Ultimac they say to do the below (source http://www.ultimarc.com/avgainst.html ) My question is should this be enabled and the arcade vga section be set to off or should it be set to on and this shouldnt be put in mame settings? or should both be set? Thanks Guys MAME Configuration (General) This step is VITAL. If you do not do this you will not get any of the benefit of the ArcadeVGA card. By default MAME is configured to stretch and re-process the picture to fit on whatever resolution your PC happens to be running at. YOU DO NOTWANT THIS TO HAPPEN because using the ArcadeVGA card you can have un-distorted video with a one-to-one pixel mapping. The basic changes you need to make are: HARDWARESTRETCH MUST BE OFF YOU MUST USE DIRECT-DRAW NOT DIRECT 3D SWITCH RESOLUTIONS MUST BE ENABLED The command-line switches to do this if running Mame from a commandline are: -videoddraw -nohwstretch -switchres Post config in a seconds
