digitalpowertrip

@rablack97 - Thanks for the follow-up. This is exactly what I am experiencing. If I load a table, I can just close it out and go back in and all is well. It happens after every boot. I only need to one time and I am good until I reboot again. I have a ticket in with ZEN, but doubt they do anything with it.

@rablack97 - 2.62 I think...

@rablack97 - I also noticed that if I launch an FX3 table from PBX (it comes up in desktop mode) then quit that table, the next time I launch an FX3 table, it works correctly. I have now tried online and offline Steam modes with the same results from PBX.

Yes, using the boot with Windows from PinballX, I didn't know there was an offline version (It's through Steam). Once I put in the code one time it works fine until I boot again. Or, If I boot to the desktop launch FX3... exit then launch PBX it also works fine. 1. Three screens, no addressable LEDs or Feedback devices. 2. Yes to DMDext no to the others 3. FX3 only 4. Any FX3 table 5. Yes only when launching an FX3 table with PBX (works fine if I don't boot to PBX and launch FX3 as a stand-alone. 6. I'll have to dig that up when I'm back at home. Thanks!

I have noticed that if I launch PinballX on startup, I always have to enter my cabinet code from ZEN the first time I try to launch a table in FX3. If I disable boot with windows and launch FX3 standalone, it has my code and all works normal. Is there a way around this to get PinballX to launch FX3 tables without having to enter the code once each fresh boot?

I figured it out. I had to put: Sub Table1_exit() Controller.Pause = False Controller.Stop End Sub Into the table script. It was set to True and that made the table wait until the DMD animation finished before the table was active... it was a long animation!

I'm having a similar issue. I had a B2S that was not working... but table worked fine. When I finally got it working, my table loses focus and I have to alt tab to it or click on it to get the buttons on my cab to work.